![]() ![]() You just have to click Simulation mode as shown.īut, in this software, there is no IP address assigned for simulation mode. You just have to click Simulation as shown.Īfter the program has been downloaded, just put the PLC in run mode and you can check it in simulation.īut, in this software, there is no IP address assigned for simulation mode. Unity Pro is the common programming, debugging and operating software for the Modicon M340, M580, Premium and Quantum PLC ranges. After the program has been downloaded, just put the PLC in run mode and you can check it in simulation. It too takes the IP address of 127.0.0.1. You just have to click Launch Simulator as shown below. You cannot put any other address for simulation. Note that the IP address must be 127.0.0.1 for simulation mode. available on the Schneider Electric website to download and can be used as a free. With these steps, you can check the logic in simulation mode. In this tutorial, we cover Schneider Electric Modicon M241 PLC and CFC. Click OK then you can do the PLC simulation.
0 Comments
Leave a Reply. |